phpbnvspoc

[morales6]

hi techs, I have a DINEX LCD37 that shows only half picture (left side) I have checked the two ribbons connectors that comes from the panel and connect to the logic board for any bad connection but all seems be ok, the panel lit ok but when I connect any signal like antena or video, the set shows only half screen. any suggest or idea will be appreciate it. thanks in advance. jose

[Eddie]

Hi Jose,

Is there anyway you can take a photo of the TV? Is it exactly half of the picture? Is the picture only being lit up on the left side and not on the right or are you not getting picture period? These things will help narrow down the possibilities. Also, what's the exact model number of the unit?

[morales6]

Hi Eddie, thanks for your respond. the complete screen lit up, but only shows exactly half picture when I connect the antena or any video in put. model no. DX-LCD37. thanks again.

[Crowell]

Ok, it is very common issue on these Dynex LCD TVs that the connector (especially the flat one) that goes from the Logic board to the LCD is loose, how ever you can try and clean it with clean cloth dipped in alcohol, just to make sure no rust is in there. If still nothing happens then my second recommendation is to change the logic board, you might want to search for it buy part number, try this guys first, they have very low prices: http://www.discount-merchant.com/
And worst case scenario, it’s the LCD, if that’s the case the I would suggest you buy a new TV, the LCD cost above 350 bucks. Good luck.

[morales6]

Hi crowel, thanks for your suggest, I already have cleaned the logic board connector and did not helped, and I did order a new logic board from these guys. I''ll let you know later. thanks again.

[morales6]

Hi crowel. the set finally is fixed, the problem was the logic board I ordered the part from DM. thanks again for your help. Jose.

[AmyfUp]

cheapest zovirax cream