Hi,
I just replaced my color wheel for my HLN437W DLP and the picture is fine through S-video, and Composite (red/white/yellow)
Now I can't get a picture through the Component inputs. My model has 3 sets, I have tried all 3 and it cannot recieve a signal. It does recognise that something is connected to it through the source selection though.
Any help or suggestions would br greatly appreciated.
Thanks.
runiozub
Moderator: Angel
Re: HLN437W No component signals after color wheel rep
Problem solved:
The 2 components I was trying to hook up were set to 1080i and would not show up until I hooked them back up to my New Samsung LCD and reduced the input setting to 1080p.
(xbox 360 & a older Sony dvd theater in a box)
Well at least I found this site, It has alot of info.
Thanks again.
The 2 components I was trying to hook up were set to 1080i and would not show up until I hooked them back up to my New Samsung LCD and reduced the input setting to 1080p.
(xbox 360 & a older Sony dvd theater in a box)
Well at least I found this site, It has alot of info.
Thanks again.
Re: HLN437W No component signals after color wheel rep
Glad you found out what was wrong. I had no idea on this one. I have the same tv in my bedroom. I picked it up for free. It had issues of turning off at random times when I picked it up. It just had bad solder joint issues in the power supply.
I was lost why you lost signals after color wheel replacement.
I was lost why you lost signals after color wheel replacement.
