mcfxtaus

Moderator: Angel

Post Reply
tahoe642
Newbie
Newbie
Posts: 1
Joined: Sat Jul 11, 2009 1:02 pm

WD-Y57

Post by tahoe642 » Sat Jul 11, 2009 1:15 pm

Does anyone know how to reset the lamp counter on a mitzubitsi WD-Y57 DLP TV

User avatar
Angel
Site Admin
Site Admin
Posts: 446
Joined: Sat Apr 04, 2009 1:52 am

Re: WD-Y57

Post by Angel » Mon Jul 13, 2009 2:33 pm

Unplug the TV, wait a minute and plug it back. Then turn it back ON.

In Mitsubishi TVs after replacing the lamp and turning the unit back ON there should had been a message asking you if you replaced the lamp? Press ENT(er) for Yes or CANCEL for No.

Hope this helps.
The best "Do It Yourself" site for all types of Displays!

Rivers85
Contributor
Contributor
Posts: 11
Joined: Mon Aug 03, 2009 2:12 pm

Re: WD-Y57

Post by Rivers85 » Mon Aug 03, 2009 5:05 pm

//Lamp Timer Reset
When you open the back cover door to replace the bulb, the lamp timer should automatically reset but if it doesn't then try either one of the next options:

//System Reset
Press the SYSTEM RESET button on the front panel with a pointed object, such as the point of a pencil or end tip of a paper clip. The green LED will flash quickly for about one minute.

When the green LED stops flashing, you may turn on the TV. The changes you made most recently, before using SYSTEM RESET, may be lost. Changes you made previously, however, are not lost.

//TV Reset Menu
1. Select any device from the Input Selection menu.
2. Press MENU followed by 1 2 3 to open the Reset Service Menu. CAUTION: All settings except V-Chip will be reset to the original factory defaults Read on-screen warnings before proceeding, as some user data or settings may be erased.
3. Press ENTER to reset TV defaults.

//WD-Y57 Manual
Here is the link to download your TV manual: http://www.fixyourdlp.com/blog/2009/04/ ... tion-tv’s/

JanefUp
TV Wizard
TV Wizard
Posts: 753
Joined: Sun Apr 12, 2020 9:57 pm

mcfxtaus

Post by JanefUp » Fri Nov 25, 2022 10:47 am


Post Reply

Return to “Akai DLP Discussion”