Page 1 of 1
Color problems after color wheel replacement
Posted: Thu Jul 01, 2010 11:33 pm
by beamancr
I just replaced the color wheel in my DLP (Model HLR4266WX/XAA) and now the picture is horrible. The colors are totally off. I've read something about "jump" cables, can anyone help? Can't afford a repairman. Thank you!
Re: Color problems after color wheel replacement
Posted: Thu Aug 12, 2010 8:00 pm
by darkart77
f you are installing this FAB Bearing (SILVER) Colorwheel + Housing, in place of your FDB Bearing (GOLD) Colorwheel you will need to REMOVE a jumper ("OPEN") on the DMD Board (Jumper CN810). This jumper is on the BACK SIDE of the DMD Board (usually covered by an aluminum panel--you do not need to take this panel off unless you have trouble accessing the jumper
mwwidbmg
Posted: Sun Feb 19, 2023 12:45 am
by JackfUp