Powering on the TV, I get the blue power LED (steady) and the temp and lamp LEDs light up briefly, then turn off. The fan kicks on for about 2 seconds, then shuts off. the power LED remains on, but nothing else happens. This is a 50v500, and the old light engine was giving me the blue crap all over the screen. I got this replacement light engine out of a working TV.
Any ideas? Everything is tightly connected, from what I can see, unless I just blatantly missed a connector.
pzewoanf
Moderator: Angel
-
DarcSystems
- Newbie
- Posts: 2
- Joined: Sat Feb 12, 2011 11:49 pm
-
grayfox
- Jedi Master
- Posts: 1049
- Joined: Sat Jun 13, 2009 9:40 pm
- Location: Sunny San Diego!
- Contact:
Re: Replaced light engine, powers on, but no picture
Hello,
normally I would mark this down as a DMD issue and replace the light engine, but you mention you have done this? have you tried both the new and old DMD board? (assembled to the engine itself)???
If that still doesn't solve your problem I would try another DMD board/light engine
...
hope this helps!
normally I would mark this down as a DMD issue and replace the light engine, but you mention you have done this? have you tried both the new and old DMD board? (assembled to the engine itself)???
If that still doesn't solve your problem I would try another DMD board/light engine
...
hope this helps!
Unit Foxhound-
DarcSystems
- Newbie
- Posts: 2
- Joined: Sat Feb 12, 2011 11:49 pm
Re: Replaced light engine, powers on, but no picture
Thanks for the reply. I put the old one back in, the TV fired up just fine, so I'm going to say this replacement light engine is no good. I've contacted the guy who sold it to me, and requested a refund.
Thanks again.
Jay
Thanks again.
Jay
-
grayfox
- Jedi Master
- Posts: 1049
- Joined: Sat Jun 13, 2009 9:40 pm
- Location: Sunny San Diego!
- Contact:
Re: Replaced light engine, powers on, but no picture
O good to hear as long as the TV is up and running!
as long as the TV is up and running!Unit Foxhound