odhbnacs

Moderator: Angel

Post Reply
Nator52
Newbie
Newbie
Posts: 2
Joined: Wed Sep 29, 2010 7:00 pm

lamp on no picture

Post by Nator52 » Wed Sep 29, 2010 8:41 pm

I have a Samsung model # HL-R5667W, when I first turn on the set the lamp comes on but no picture. The stand by / temp light comes on, does not blink, and after a few minutes shuts off. If I unplug the tv for a few seconds and plug it back and turn on the power everything works fine for as long as it's on, once I turn it off and come back later to turn it on the same thing happens. I changed the lamp and reset the hours and it still does the same thing. What could be the problem, I also cleaned the dust from the back of the set but since this happens when cold I doubt it is a heat issue.

User avatar
BYO
Tech Junkie
Tech Junkie
Posts: 103
Joined: Fri Mar 13, 2009 12:01 am
Location: San Francisco CA

Re: lamp on no picture

Post by BYO » Wed Jun 01, 2011 3:55 pm

:shock: If you can see that the lamp turns ON and you still dont have a image, :idea: most probably your DLP chip is bad, this is a very well known issue with Samsung's. Please check the following info:

:arrow: http://www.youtube.com/watch?v=eD_xZcYQE50
:arrow: http://www.dlp.com/technology/how-dlp-w ... fault.aspx
:arrow: http://electronics.howstuffworks.com/dlp1.htm

:idea: After reading this you will comprehend that the DLP chip stops working and all of the micro-mirrors are on the OFF position.

:!: The last picture on this link shows you the enclosure of the DMD board
http://www.discount-merchant.com/PhotoD ... =SKU110235
Apparently the part # of the DMD board is BP94-02217B
Change is the only constant, we must become the change we want to see.

Wimlok
TV Wizard
TV Wizard
Posts: 481
Joined: Fri Apr 24, 2020 10:59 pm

odhbnacs

Post by Wimlok » Sun Mar 05, 2023 8:27 pm


Post Reply

Return to “Akai DLP Discussion”