Page 1 of 1

DYNEX LCD37 HALF PICTURE (LEFT SIDE)

Posted: Mon Feb 15, 2010 4:10 am
by morales6
hi techs, I have a DINEX LCD37 that shows only half picture (left side) I have checked the two ribbons connectors that comes from the panel and connect to the logic board for any bad connection but all seems be ok, the panel lit ok but when I connect any signal like antena or video, the set shows only half screen. any suggest or idea will be appreciate it. thanks in advance. jose

Re: DYNEX LCD37 HALF PICTURE (LEFT SIDE)

Posted: Mon Feb 15, 2010 6:24 pm
by Eddie
Hi Jose,

Is there anyway you can take a photo of the TV? Is it exactly half of the picture? Is the picture only being lit up on the left side and not on the right or are you not getting picture period? These things will help narrow down the possibilities. Also, what's the exact model number of the unit?

Re: DYNEX LCD37 HALF PICTURE (LEFT SIDE)

Posted: Tue Feb 16, 2010 11:21 pm
by morales6
Hi Eddie, thanks for your respond. the complete screen lit up, but only shows exactly half picture when I connect the antena or any video in put. model no. DX-LCD37. thanks again.

Re: DYNEX LCD37 HALF PICTURE (LEFT SIDE)

Posted: Wed Feb 17, 2010 9:08 pm
by Crowell
Ok, it is very common issue on these Dynex LCD TVs that the connector (especially the flat one) that goes from the Logic board to the LCD is loose, how ever you can try and clean it with clean cloth dipped in alcohol, just to make sure no rust is in there. If still nothing happens then my second recommendation is to change the logic board, you might want to search for it buy part number, try this guys first, they have very low prices: http://www.discount-merchant.com/
And worst case scenario, it’s the LCD, if that’s the case the I would suggest you buy a new TV, the LCD cost above 350 bucks. Good luck.

Re: DYNEX LCD37 HALF PICTURE (LEFT SIDE)

Posted: Thu Feb 18, 2010 5:47 am
by morales6
Hi crowel, thanks for your suggest, I already have cleaned the logic board connector and did not helped, and I did order a new logic board from these guys. I''ll let you know later. thanks again.

Re: DYNEX LCD37 HALF PICTURE (LEFT SIDE)

Posted: Fri Feb 26, 2010 3:46 pm
by morales6
Hi crowel. the set finally is fixed, the problem was the logic board I ordered the part from DM. thanks again for your help. Jose.

phpbnvspoc

Posted: Mon Jan 23, 2023 12:14 pm
by AmyfUp